End mill grinding method is as follows:

End mill grinding method is as follows:

1. End mill edge grinding:

With the original holder R8 chuck holding the milling handle, according to 90 ° horizontal end mill milling accessories, pull up the limit screw, turn the turret can be reversed 360-degree knife turret transferred to the grind end position , And then according to the end of the cutting edge of the point of view, grinding out the angle of the rear edge of the blade edge, pay attention to grinding when grinding approach. After grinding with a knife rack indexing equipment Tool reversal 45 degrees (4 edge) or 90 Degree (2 blade) Grind another blade.

2. End milling cutter milling edge:

The original turret table for the mill milling cutter attachment table. Pierce the R8 sleeve into the conical bore of the milling cutter attachment table to pierce the R8 sleeve into the R8 sleeve and secure it so that the spiral mill will no longer roll. Adjust the end mill cutter to a base higher than the grinding wheel. According to the milling cutter side angle after the degree of rolling 0-40 degrees turret table, the end mill attachment table adjusted to the appropriate sharpening point of view. Helical end mill sharpening accessories on the guide adjustable bracket fixed slotted needle to close the end cutter helical groove side of the guide guide, and then immediately after the early years to free rotation (guided by the guide) to push some of the front and rear Tic sharpening grinding method grinding cutter angle after the helical cutting edge. When the main post-angle grinding mill after Vice-angle, the guide fixed bracket fixed slot needle into the second inclination of the spiral groove, and then the same as the top of the grinding angle to the same grinding.